My pad in progress

Ghettobarney · Trick Member Joined: 21 Dec 2006 Location: Failing Pandy

Yay, I'm about 75% done with my homemade pad using riptides design, except with more arcade like sensors. Right now the bar is 2x2's, so anysuggestions for making a steel/pvcpipe bar would be apreciated.

Thank you riptide for an awsome design. I Also plan on adding lights soon!
_________________

OMG I BEETS MACKS 300!

MasterInuYasha · Posted: Sat Feb 03, 2007 11:33 pm Post subject:

Nice!

I am going to make a diff Sensor design too.. as well as using 3/8 thick panels... Or even 1/2'' thick just because I am all about OVERKILL

Ghettobarney · Trick Member Joined: 21 Dec 2006 Location: Failing Pandy

Why not just use 1"?

_________________

OMG I BEETS MACKS 300!

MasterInuYasha · Posted: Sun Feb 04, 2007 10:57 pm Post subject:

slvrshdw · Trick Member Joined: 05 Jan 2005

do you mind if i use your pics in a tutorial im making?

i'll give you credit for the pics i use of course, i just wanted to make sure it was all right with you.

anyway, i hope it's ok with you
_________________

Ghettobarney · Trick Member Joined: 21 Dec 2006 Location: Failing Pandy

Sure! In fact, I'm almost done! I'm making a new bar out of pipes. Heres more pics of the inside.

Some of the sensors are smaller becuase Home Depot didn' have enough of the same size, but other wise there the same.

I just did this. I dont remember who came up with the idea, but it works good.

Figuring out lighting is so hard, I'm such a noob...
_________________

OMG I BEETS MACKS 300!

slvrshdw · Trick Member Joined: 05 Jan 2005

im pretty sure matrix designed the sensors.

cool, i should have something to do in my web class now :-p

now i just gotta get my own pad worked on >.>
_________________