| View previous topic :: View next topic |
| Author |
Message |
dj_sammylvr03
Trick Member
Joined: 20 Jun 2004
Location: Connecticut, US |
0.  Posted: Mon Jul 17, 2006 5:28 pm Post subject: Having Problems With Your Ignition |
 |
|
Ok. We all had those problems with our Ignition crapping out a few days after we bought it. It has awful timings and has many ghost steps. Here is a quick 10 minute fix to make those shost steps go away, and make the response way better.
1.)Unzip your ignition.
2.)Cut 4 small squares of thin wood (plywood works fine) in 22.5 cm X 25.5cm
3.)Locate the 4 arrow sensors on the pad and ducttape the 4 squares onto the foam insert below the sensor.
4.)Zipper the pad back up and give it a try!
NOTE: Results May Vary.
_________________
|
|
| Back to top |
|
 |
DARREN HAYEZ
Trick Member
Joined: 13 Apr 2006
Location: Michigan |
| 1. Posted: Mon Jul 17, 2006 5:44 pm Post subject: |
|
|
My problem is the risers in the pad moving. But maybe if I just taped a piece of plywood under the left (riser IN THE MIDDLE) and right (riser slightly off) that would fix it. I definately need to try this! 
_________________
|
|
| Back to top |
|
|
dj_sammylvr03
Trick Member
Joined: 20 Jun 2004
Location: Connecticut, US |
| 2. Posted: Mon Jul 17, 2006 5:50 pm Post subject: |
|
|
| Commodore Apocalypse! wrote: | | My problem is the risers in the pad moving. But maybe if I just taped a piece of plywood under the left (riser IN THE MIDDLE) and right (riser slightly off) that would fix it. I definately need to try this! |
I had that problem with my first ignition. It was a 2.0 and the left riser moved into the center.
_________________
|
|
| Back to top |
|
|
orb
Trick Member
Joined: 20 Nov 2002
|
| 3. Posted: Mon Jul 17, 2006 7:45 pm Post subject: |
|
|
Better solution: Return the Red Octane model and purchase a BNS pad.  |
|
| Back to top |
|
|
|
Forums FAQ
Search
Memberlist
Usergroups
Register
Profile
Login to check your private messages
Login
