PIU arow sizes?

rbh221 · Trick Member Joined: 05 Feb 2006

Now that I am building a DDR metal pad I thought maby I should try to build a PIU pad next. But I don't know what size that arows are so... my questions are:
1. What sizes are the up-left, up-right, down-left, down-right, and center buttons?
2. And is there a place online where I can download the arow graphics for PIU?
Thanks

rbh221 · Trick Member Joined: 05 Feb 2006

Does anybody know? Sorry, I have not seen a PIU arcade machine.

NVWC2006 · Basic Member Joined: 23 Dec 2005

i do not know the size of the buttons nor do i know of any graphics.

however...

i know a Cobalt Flux can be used for PIU. so i suspect that the squares for a dance pad's buttons would be the same size as PIU, and even if they aren't, they must be fairly close.

Flazh · Trick Member Joined: 09 Oct 2003 Location: Leeds, England

Remember that PIU arrows are offset so that they overlap the centre on the sides... As far as dimensions go, this should give you a good idea of what size the pad is at least... perhaps you could work it out from there? Unfortunately I don't go to my local PIU ever as its a bit of a walk through my city and its only a PREX, so its not really worth it. I'm sure someone could measure for you...

rbh221 · Trick Member Joined: 05 Feb 2006

irvineking1980 · Posted: Thu Feb 16, 2006 10:03 pm Post subject:

I will go to arcade shop tomorrow and measure it for you.

rbh221 · Trick Member Joined: 05 Feb 2006

Thank you thank you thank you!

zombiejesus9001 · Trick Member Joined: 05 Apr 2004

so incase anyone is wondering here are the pump measurements

the metal plate on the right and left side of the pad is 6.5 inch's down and 11 across

diagonal arrows are 13.25 inch's down and 11 across

the bar is 37 inch's tall and 21 inch's wide

enjoy

klenta · Posted: Sat Feb 18, 2006 12:06 pm Post subject:

Is the center the same size as the diagonal arrows? *just curious*
_________________

zombiejesus9001 · Trick Member Joined: 05 Apr 2004

im believe so i i just measured the corners and stuff for modding my cf pad

see

rbh221 · Trick Member Joined: 05 Feb 2006

So, are the metal panels between the up-left and up-right and down-left and down-right the same as the ones between the up-left and down-left and up-right and down-right?

zombiejesus9001 · Trick Member Joined: 05 Apr 2004

wha? explain

rbh221 · Trick Member Joined: 05 Feb 2006

Are the left and right metal panels the same as the up and down ones?

yagsimit69 · Trick Member Joined: 05 Jan 2004 Location: rochester

rbh221 · Trick Member Joined: 05 Feb 2006

I mean the size.