ignition 3.0 non slip?

HackaX0rus · Basic Member Joined: 27 Nov 2005

i recieved my ignition pad for christmas today and i am very pleased with it...however their "non slip" surface on the bottom doesnt cut it on the carpet...it actually slips more than my little brothers mario mix (i am playing harder songs on this however)...any ideas to firmly plant the pad where i put it?
_________________

i suck at ddr...

dylanâ¢ · Trick Member Joined: 27 Oct 2005 Location: versailles KY

my advice
good old duct tape works fine
or you could nail it to a piece of wood

HackaX0rus · Basic Member Joined: 27 Nov 2005

i was thinking about getting one of those roller mats you lay down on carpet for rolly office chairs...and double side sticky taping or duct taping the mat to it...so it had little carpet spikes...
_________________

i suck at ddr...