RO Afterburner Pinout Cbox Information?

[Tweder]

So... I'm fed up with the issues Stepmania has with the Afterburner, so I decided I'll build myself a new control box. I have mostly everything ready, I just need to know the pin infomation of the 9 pin cable the Afterburner uses. For example, I need to know which wire is ground and which wire is up, down, etc...

I need to know because I am going insane with the problems... Please Help!

[theheter0c1ite]

Ok, simple. I don't have an afterburner, but all you need to do to figure out the pinout is use an ohm meter. I don't have an afterburner, but if you can actually touch one end of the leads to the ground, or find what all the buttons are common to. A good place to start would be either pin 1, or 9. After that, everything else should be as simple as stepping on the buttons until you find which button goes to what pin. Simple? Yes. Time consuming? Yes. Have fun.

[Cutriss]

And if that doesn't work, use the Afterburner thread next time.
_________________

Sentient Mode is capable...