Search found 8 matches

yea my 2.0 started to die after about 3 months, i finally said fu** it and made a metal pad which is almost done :-)

ok so i soldered the wires and everything works perfectly! thanks for the hlep guys. i think i might have actually discovered a new way to solder for the ground wire, unless im just stupid and didnt u ...

the previously black ones.

thanks man. i already scraped the black stuff off because i hadnt read this yet and also when i scraped the black stuff off i accidentally scraped a little bit around the copper parts(where the black ...

thank you very much! i just have one more question. where do i solder for the ground on a ps1 controller. there isnt any specific point labeled on the controller like there is for up, down, left, etc. ...

is the diagram of the circuit board from the red octane pad (on the page before this one) the same on any circuit board. could i take one out of any of my soft pads and would the solder points be the ...

Working on the pad right now, trying to cut out the Acrylic. What did you all do to cut that out, we're having a lot of troulbe with it outselves.

well i just cut my acrylic yesterday and here are ...

so i know this is completely off topic, but i dont wann go looking through all the posts just to find the answer to this question, and im probably gonna get falmmed for this, but what the crap ever ha ...